Iphone 5 impossibile attivare rete dati cellulare

I was able to skip removing the display assembly and logic board steps and lay the speaker upside down on the bottom edge of the logic board without putting undue pressure on the antenna cable making this a much easier and quicker repair for me. If you choose to leave the display assembly connected, I recommend using a rubber band to hold it to a box of similar size at a 90 degree angle to prevent damage and stress to the attached cables. Either a 00 or a bit should work fine here. Some 0 bits will also work if the point is fine enough. Same goes for a lot of JIS bits. As long as it doesn't strip or slip, you're good.

My kit's screwdriver failed about the time I got to the last few steps in this tutorial. I had a cheap precision set with a bit but that refused to seat in the screws. I went to Home Depot, bought a lifetime guarantee Husky precision set with through 0 bits and that worked beautifully on every screw.

And if so what are the benefits of removing it? Cause i had quite a hard time putting back in the connectors of the 3 flex cables. I have the 6s from Dubai. I am stuck on this screw. A precision screwdriver set is a wise investment for doing any of this work. I got a set from iFixit that is very well machined.

The kit provided with the replacement Battery of iPhone 6s does not include the right bits to remove the three 1,2mm screws! I had to remove it without removing the display. I too experienced a problem with the size of the screwdriver here supplied in the iFixit kit. My phone also had a 5th screw right in the center of the plate - another 1. I removed and replace it without problems. These instructions are for the 6s.

It has been invaluable and the set includes enough screws that I have been able to cover all that have been dropped and lost for 3 i-Phones now. Using a magnetic mat has also limited my screw loss considerably!

Riavviare l'iPhone o l'iPad

The ifixit kit supplied screwdriver for the display cable bracket did NOT fit. Leaving the screen attached and then removing and replacing the battery. Note carefully the order that they are removed. My new display had them in the WRONG order and I spent about 2 minutes trying to figure out what was wrong until I compared the new screen with the old screen and saw that they were in wrong sequence.

Fortunately they were relatively easy to fold out of the way and put them in the right order. After that they popped right into place. I pop up these screen connectors using my fingernail. After doing a lot of repairs, this is the easiest and fastest way to get them loose. Quando devi riattaccare il cavo del digitizer, non premere nel centro del connettore. Premi da un lato e poi dall'altro.

Bug iOS 9, impossibile modificare l’uso dati cellulare per singole app

Recolor that "pinned" note about not pushing on the center in "RED" if you get a chance. Yes--if you, like me, could not get the digitizer connector to seat, you've probably got confused on the reassembly order. I had to remove the EMI shield seven screws , and reinstall it ON TOP of the big flap tongue that comes with the new digitizer, rearranging the order of the connector tails. Note that one of the connectors is a bit shorter than the other, and one of the receptacles on the iPhone is shorter as well.

Make sure you're laying down the tails and connectors in the right order when you reassemble!

The display data cable--sideways to the others, toward the outer edge, goes first. Then the longer connector, and finally the shorter one. When they're seated, they're seated, and you'll be sure of it.

I notice there are 3 flex cables, does this disassembly guide apply to the verizon version of iPhone 6s? I don't want to order the wrong digitizer screen for my new and improved iPhone that i somehow managed to crack the screen on.

iPhone: tasti rotti e/o inaccessibili? Ecco qualche rimedio

There are four cables to disconnect here to complete this process, at least on my phone. The replacement screen also had 4, so no problem. I am having a hard time reattaching the LCD cable. Is it possible I bent the connectors? Or possibly the gaskets around it are interfering? I neglected to detach the battery before taking this step and upon reassembly I have no display. What might be my next step to repair. If you power on your phone and you can see an image on the display by shining a bright light on it, your backlight circuit is toast.

Tutte le sezioni di telefonino.net

This is a common repair and very fixable, but requires microsoldering equipment and expertise. My screen replacement only comes with two flex cables but all of the videos are showing three. It is not working to connect the flex cables to the connectors. The third flex cable would be for the front-facing camera, sensors, etc. The instructions are over here. In fase di rimontaggio, fermati qui se vuoi sostituire l'adesivo attorno ai bordi del display. If you're replacing the adhesive, be sure to check the two tabs on the display that receive the pentalobe screws before setting the display on the new adhesive.

Se l'hotspot personale non funziona sul tuo iPhone o iPad (Wi-Fi + Cellular)

The tabs on my display were bent inward slightly—just out of reach of the pentalobe screws. Altoparlante Mifa, in sconto, suona anche in stereo: Smartwatch e robot Xiaomi in sconto flash a partire da 48 euro 8 Ago Estate al top con Yi Action Cam custodia subacquea in sconto a 34,99 euro 7 Ago Recensione Honor 10, il top di gamma Android più economico 8 Ago Recensione Anker Roav F2: Bluetooth, MP3 e caricatore auto tutto-in-uno 7 Ago Recensione cavalletto video Andoer, riprese fluide con reflex e smartphone 6 Ago I migliori microfoni per iPhone e iPad per videomaker, youtuber e giornalisti 20 Lug Se sei in viaggio all'estero, assicurati che il dispositivo sia configurato per il roaming dati.

Riavviare l'iPhone o l'iPad Riavvia il dispositivo. Verificare la disponibilità di un aggiornamento delle impostazioni relative all'operatore telefonico Per verificare manualmente e installare un aggiornamento delle impostazioni relative all'operatore telefonico: Assicurati che il dispositivo sia connesso a una rete Wi-Fi oppure a una rete cellulare.

Se è disponibile un aggiornamento, visualizzi un'opzione che consente di aggiornare le impostazioni relative all'operatore telefonico. Contatta il tuo operatore Eventuali problemi con l'operatore o con l'account potrebbero influire sul servizio. Verificare che il tuo account sia attivo e in regola. Assicurarti che la tua area non sia interessata da interruzioni del servizio.